Pinnacle PCTV SAT CI PCI DVB-S DE EN NL Ret +rem 202261451 Manuel D’Utilisation
Codes de produits
202261451
90
PCTV Sat (CI)
W
HAT ELSE IS IMPORTANT
?
"Either … or …"
At the present time, the DataReceiver cannot be used at the same time as the
TV application PCTV Vision or the Teletext application WebText.
TV application PCTV Vision or the Teletext application WebText.
The computer must be switched on
It may happen that a requested download from an Internet Satellite Provider
does not begin immediately. In this case, you will be advised of a time for
the download.
does not begin immediately. In this case, you will be advised of a time for
the download.
Therefore, when you have requested downloads from an Internet Satellite
Provider and have made all the required settings in the DataReceiver
application, your computer must be switched on at the time advised for the
transmission of data.
Provider and have made all the required settings in the DataReceiver
application, your computer must be switched on at the time advised for the
transmission of data.
Maintain transponder settings
When you have requested downloads from an Internet Satellite Provider and
have made all the required settings in the DataReceiver application, the
transponder settings must be maintained until the end of the data
transmission, as otherwise you will not be able to receive the data.
have made all the required settings in the DataReceiver application, the
transponder settings must be maintained until the end of the data
transmission, as otherwise you will not be able to receive the data.
S
TARTING
D
ATA
R
ECEIVER
After the system requirements described above have been fulfilled, start the
DataReceiver from the Pinnacle program group.../Tools/DataReceiver.
DataReceiver from the Pinnacle program group.../Tools/DataReceiver.
The color of the satellite icon in the task bar at the bottom right shows the
application's current receiving status:
application's current receiving status:
completely green = data are currently being received from
the Internet
completely grey = the application is active, but no data are
being
received