SEAL 44/62 Manuel D’Utilisation
30
Troubleshooting
8 TROUBLESHOOTING
List of common problems and solutions that the user can correct:
Problem
cause
solution
The power LED does not
come on, when the machine
is switched on.
come on, when the machine
is switched on.
there is no power
check if the power cable is
plugged into the mains wall
outlet.
check the fuse located on the
rear side.
plugged into the mains wall
outlet.
check the fuse located on the
rear side.
LED power is flashing
the voltage from the
supplier is too low
supplier is too low
Machine voltage 115V:
the incoming voltage must be
between 90-130V AC.
Machine voltage 230V:
the incoming voltage must be
between 200-250V AC.
the incoming voltage must be
between 90-130V AC.
Machine voltage 230V:
the incoming voltage must be
between 200-250V AC.
LED Forward and reverse
are flashing
are flashing
Drive-motor is in
overload
overload
the machine is in overload
restart the machine
restart the machine
For technical assistance, please contact your technical service representative (see front
cover)
cover)