Lenovo 019726U Manuel D’Utilisation
Error messages
Table 3. Error messages
Symptom or error (beeps, if any)
FRU or action, in sequence
Bad CRC2. Enter BIOS Setup Utility, and
load Setup defaults.
(two short beeps)
load Setup defaults.
(two short beeps)
Press F1 to enter BIOS Setup Utility. Press
F9, and Enter to load the default setting.
Then save the current setting by pressing
F10, and restart the computer.
F9, and Enter to load the default setting.
Then save the current setting by pressing
F10, and restart the computer.
Fan error.
(four short beeps, one long beep)
(four short beeps, one long beep)
1.
Fan
.
2.
Thermal grease.
3.
System board.
DRAM is unplugged.
(one short beep, pause, three short beeps,
pause, three short beeps, pause, one short
beep.)
(one short beep, pause, three short beeps,
pause, three short beeps, pause, one short
beep.)
Memory card is not installed. Install
memory card.
memory card.
DRAM is not well plugged.
(one short beep, pause, three short beeps,
pause, three short beeps, pause, one short
beep.)
(one short beep, pause, three short beeps,
pause, three short beeps, pause, one short
beep.)
Reinstall the memory card.
Operating system not found.
1.
Check that the operating system has no
failure and is installed correctly.
failure and is installed correctly.
2.
Enter BIOS Setup Utility and see whether
the hard disk drive is properly identified.
If you still see the same error message,
check the boot sequence.
the hard disk drive is properly identified.
If you still see the same error message,
check the boot sequence.
3.
Reinstall the hard disk drive.
4.
Reinstall the operating system.
System Configuration Data Read Error
(two short beeps)
(two short beeps)
Press F1 to enter BIOS Setup Utility. Press
F9, and Enter to load the default setting.
Then save the current setting by pressing
F10, and restart the computer.
F9, and Enter to load the default setting.
Then save the current setting by pressing
F10, and restart the computer.
No-beep symptoms
Table 4. No-beep symptoms
Symptom or error
FRU or action, in sequence
No beep, power-on indicator on, LCD blank,
and no POST.
and no POST.
1.
Make sure that every connector is
connected tightly and correctly
connected tightly and correctly
.
2.
DIMM.
3.
System board.
No beep, power-on indicator on, and LCD
blank during POST.
blank during POST.
1.
Reseat DIMM
.
2.
System board.
The power-on password prompt appears.
A power-on password or a supervisor
password is set. Type the password and
press Enter.
password is set. Type the password and
press Enter.
The hard-disk password prompt appears.
A hard-disk password is set. Type the
password and press Enter.
password and press Enter.
56
ThinkPad Edge 13
″ and E30 Hardware Maintenance Manual