Emerson MVME55006E Manuel D’Utilisation
MVME55006E Single-Board Computer Installation and Use (6806800A37D)
Connector Pin AssignmentsEthernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6, J7, J28, J32, J34, J97
90
5.3.1.2
PMC/SBC Mode Selection
Two 3-pin planar headers on the MVME5500 are for PMC/SBC mode selection. For PMC
mode, install jumpers across pins 1-2 on both headers. For SBC/IPMC761 mode, install
jumpers across pins 2-3 on both headers. For SBC/IPMC712 mode, install a jumper across pins
2-3 for J32 and install a jumper across pins 1-2 for J28. Selection notes follow the table. The
pin assignments for these headers are as follows:
mode, install jumpers across pins 1-2 on both headers. For SBC/IPMC761 mode, install
jumpers across pins 2-3 on both headers. For SBC/IPMC712 mode, install a jumper across pins
2-3 for J32 and install a jumper across pins 1-2 for J28. Selection notes follow the table. The
pin assignments for these headers are as follows:
1.
When J28 is configured for SBC/IPMC mode, –12V is supplied to P2 pin A30. If there is an
incompatible board plugged into this P2 slot, damage may occur.
incompatible board plugged into this P2 slot, damage may occur.
2.
When J32 is configured for SBC/IPMC mode, +12V is supplied to P2 pin C7. If there is an
incompatible board plugged into this P2 slot, damage may occur.
incompatible board plugged into this P2 slot, damage may occur.
3.
Install jumpers across pins 1-2 on both headers to select PMC mode. Install jumpers across
pins 2-3 on both headers to select SBC/IPMC761 mode. Install a jumper across pins 2-3
on J32 and install a jumper across pins 1-2 on J28 to select SBC/IPMC712 mode.
pins 2-3 on both headers to select SBC/IPMC761 mode. Install a jumper across pins 2-3
on J32 and install a jumper across pins 1-2 on J28 to select SBC/IPMC712 mode.
Table 5-22 PMC/SBC Mode Selection Headers (J28, J32) Pin Assignments
J28
J32
Pin
Signal
Pin
Signal
1
Fused –12.0V
1
Fused +12.0V
2
P2_PMC1_IO (60)
2
P2_PMC1_IO (13)
3
PMC1_IO(60)
3
PMC1_IO(13)