Emerson MVME55006E Manuel D’Utilisation
Flash Boot Bank Select Header (J8)
Connector Pin Assignments
MVME55006E Single-Board Computer Installation and Use (6806800A37D)
95
5.3.2
Flash Boot Bank Select Header (J8)
A 3-pin 2 mm planar header selects the boot Flash bank. No jumper or a jumper installed across
pins 1-2 selects Flash 0 as the boot bank. A jumper installed across pins 2-3 selects Flash 1 as
the boot bank. The pin assignments for this header are as follows:
pins 1-2 selects Flash 0 as the boot bank. A jumper installed across pins 2-3 selects Flash 1 as
the boot bank. The pin assignments for this header are as follows:
5.3.3
VME SCON Select Header (J27)
A 3-pin 2 mm planar header allows the choice for auto/enable/disable SCON VME
configuration. A jumper installed across pins 1-2 configures for SCON disabled. A jumper
installed across pins 2-3 configures for auto SCON. No jumper installed configures for SCON
always enabled. The pin assignments for this header are as follows:
configuration. A jumper installed across pins 1-2 configures for SCON disabled. A jumper
installed across pins 2-3 configures for auto SCON. No jumper installed configures for SCON
always enabled. The pin assignments for this header are as follows:
Table 5-24 Flash Boot Bank Select Header (J8) Pin Assignments
Pin
Signal
1
GND
2
BANK_SEL
3
+3.3V
Table 5-25 VME SCON Select Header (J27) Pin Assignments
Pin
Signal
1
No SCON
2
SCON
3
Auto-SCON