Epson 4+ Manuel D’Utilisation

EPSON Equity 4+

 When connecting the mouse and keyboard to the

computer, be careful to plug them into the proper ports.

Although the ports are physically identical, they are not

interchangeable, and damage may occur to the main

system board if you plug the connectors into the wrong

ports.

Make sure that the drive type has been correctly selected

in the SETUP program.

It is recommended that a 16-bit, AT-type hard disk

controller be used if you are installing a drive that cannot

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, you need to use the

SETUP program to disable the built-in IDE hard disk drive

interface.
When installing a hard disk drive, see the hard disk drive

types table on page 7 and use the SETUP program to select

the correct type number for the drive. You can select a

type number that matches the parameters for the drive or

a type number with parameters having lesser values, as

long as they do not exceed the maximum capacity (in MB)

of the drive. If there is no match for the drive, you can

select a user-defined drive type (47) and enter the drive’s

exact parameters.

 When installing a copy-protected software package, first

try the installation at fast speed. If this does not work

properly, select slow speed by pressing the 

Ctrl 

and Alt

keys  and the - key on the numeric keypad

simultaneously. Try loading the program at slow speed

and then switching to fast speed, if possible.
When using a software package that uses a key disk as its

copy-protection method, try loading it at fast speed. If this

does not work, load it at slow speed.

Make sure that you do not forget the password you set up.

If you do:

1. Disable it by setting DIP switch 4 on the main system

board to OFF.

2. Then turn the computer on and off again.
3. Set DIP switch 4 to ON to enable the password function.
4. Run SETUP to enter a new password, if desired.
Users can enter a hot key designation in SETUP to secure

the system from unauthorized users. Once a password

and hot key have been set, when the hot key is pressed,

the keyboard and mouse lock until the user enters the

password.

If you cannot boot the computer from the hard disk drive,

make sure the booting sequence in the SETUP program is

set to A, C. Then boot the computer from a system diskette

in drive A.

None.

None.

None.

TM-EQ4+

Epson Equity 4+ Service Manual

PL-EQ4+

Epson Equity 4+ Parts Price List

400264700

Epson Equity 4+ User’s Guide