Epson 386/33 PLUS Manuel D’Utilisation

The tests you select will run in the following manner unless

you change the run time parameters:

Each test is performed one time (passbound)

The program waits if an error occurs

No errors are recorded to the printer, disk, or other device.

If you want to change the default run time parameters, press

to move to the Run time parameters window. (Press

 at any time to exit and return to the submenu of

diagnostic tests.)

The first run time parameter specifies the mode in which to run

the test. You see this prompt:

In Timebound mode, the program runs the tests for the amount

of time you specify; press 

 and then 

In Continuous mode, the tests run until you interrupt them;

press 

 and 

In Passbound mode, the program runs the tests the number of

times you specify. This is the default setting; press 

 if

necessary, and 

 to select the mode.

The next option is:

Press 

 and 

 if you want the program to pause when an

error occurs. This lets you view the error message, make note of

it, and then press

to continue. (Y is the default setting.)