Honeywell Model 9700-HB Manuel D’Utilisation
2 - 2
Step 2. Charge the Main and Backup Batteries
The power supply for Dolphin terminals consists of two types of battery power: the main battery pack
that is accessible from the back panel, and the backup battery that resides inside the terminal.
that is accessible from the back panel, and the backup battery that resides inside the terminal.
The main battery powers the terminal. The internal backup battery charges off the main battery and
maintains the application data stored in RAM memory for up to 30 minutes when the terminal’s main bat-
tery pack is completely discharged or removed.
maintains the application data stored in RAM memory for up to 30 minutes when the terminal’s main bat-
tery pack is completely discharged or removed.
Before Initial Use
Terminals are shipped with both batteries discharged of all power. The initial charging time for the main
battery pack is 4 hours and 8 hours for the internal backup battery. Connect the terminal to one of the
9700 series charging peripherals to charge; see
battery pack is 4 hours and 8 hours for the internal backup battery. Connect the terminal to one of the
9700 series charging peripherals to charge; see
Dolphin 9700 terminals are designed for use with the following 9700 charging devices and cables: 9700-
CB, 9700-EHB, 9700-HB, 9700-MB, 9700-NB, 9700-MC, 9700-RS232, 9700-USB.
CB, 9700-EHB, 9700-HB, 9700-MB, 9700-NB, 9700-MC, 9700-RS232, 9700-USB.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-
Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.
Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.
Charging Using the Communication Cable (9700-RS232 or 9700-USB)
Use only UL Listed power supply, which has been qualified by Honeywell with output rated at 9.5VDC
and 1.7 amps with the device.
and 1.7 amps with the device.
Ensure all components are dry prior to mating
terminals/batteries with peripheral devices.
Mating wetcomponents may cause damage
not covered by the warranty.
terminals/batteries with peripheral devices.
Mating wetcomponents may cause damage
not covered by the warranty.
1. Connect the USB or RS232 cable to the I/O
connector on the terminal.
2. Tighten the thumb screws on the cable cup to
secure the cable to the terminal.
3. Plug the power cord into the power adapter.
4. Plug the power adapter cable into the power
connector on COMM cable.
5. Plug the COMM cable into the appropriate port
on the host device.
6. Plug the power cord into a standard wall outlet.
7. The LED on the front of the terminal flashes
and illuminates as the terminal starts to
initialize the boot process.
initialize the boot process.
!
!
RS232 Connector
Host Device
Power Adapter
Cable
Cable
Or
Power
Cord
Cord
USB
Connector
Connector
COMM Cable