Apple PCI-X 133 Manuel D’Utilisation

Page de 6
© 2006, 2008 Apple Inc. All rights reserved.
073-1092 Rev. B    
2
Slot 2:
Accepts PCI-Express x8 cards (using a PCI-E riser)
6.6 inch maximum length 
25 Watt maximum power consumption
To install a card, you first insert it into a matching riser, and then install the riser into the slot. The
type of card you can install depends on the riser you use:
A PCI-E riser can go in either slot, and accepts only PCI-E cards 
A PCI-X riser can go in slot 1, and accepts only PCI-X cards 
Working Safely Inside the Xserve
Always touch the Xserve enclosure to discharge static electricity before you touch any 
components inside the Xserve. To avoid generating static electricity, do not walk around the 
room until you have finished working inside the server and have replaced the cover. To minimize
the possibility of damage due to static discharge, wear an antistatic wrist strap while you work 
inside the Xserve.
Warning: Always shut down the Xserve and disconnect the power cords before opening 
it to avoid damaging its internal components or the components you are installing. Don’t 
open the server while it is turned on. Even after you shut down the Xserve, its internal 
components can be very hot. Let it cool before you open it.
Tools Required
The only tool required for this procedure is a Phillips #1 screwdriver.
Removing the Xserve from a Rack
Alert users that the server will be unavailable for a period of time. 
1. 
Shut down the Xserve (see the Xserve User’s Guide for help) and then wait to let the Xserve 
2. 
internal components cool. 
Warning: Always shut down the Xserve before opening it to avoid damaging its internal 
components or the components you want to install or remove. Don’t open the Xserve 
or try to install or remove items inside while it is turned on. Even after you shut down 
the Xserve, its internal components can be very hot. Let it cool down for 5 to 10 minutes 
before you open it.
Unplug all cables from the Xserve. 
3. 
Note: If you have trouble releasing a cable from the back panel, try using a small screwdriver 
or other flat tool to depress the tab on the cable connector.
To avoid inadvertently unlatching a drive module during handling, use the enclosure key to 
4. 
lock the enclosure lock on the front panel.
Touch the server’s metal case to discharge any static electricity. 
5.