ArtDio IPS 1000 Manuel D’Utilisation

                                                                       

      IPS 1000 Series VoIP Gateway

 

 

15

5. Dial 

“9507#”；Assuming you are modifying for China (The last 2 digits are the regional ID) 

6. Dial 

“971#” ；Sets the new regional ID. 

7.  Hang up the phone. The device will be updated with the new region setting after it restarts (restart 

time is about 10 seconds) 

 

SIP-RG>enable 

SIP-RG #configure 

Enter configuration commands, one per line.    End with CNTL/Z 

SIP-RG(config)#regional_id 07 

SIP-RG(config)#exit 

SIP-RG#delete nvram 

This command resets the system with factory defaults.     

All system parameters will revert to their default factory settings.    All static 

and dynamic addresses will be removed. 

Reset system with factory defaults, [Y]es or [N]o? Yes 

 

 

Attention: 

Before Changing the Region ID, the system has to be reset to the default value. Therefore this step 

should be done first. 

The following instruction may keep the IP address unchanged after reset:   

“delete nvram keep_ip” 

We recommend using a traditional phone to configure the unit’s parameters, as this is the easiest way. 

The following two sections contain the procedures used to configure the IPS unit according to how you 

obtain your IP address (Static IP; DHCP or PPPoE). 

 

 

Attention: 

Every time you set a parameter item and press the “#” key to complete it, a successful setting will be 

confirmed by three equal tones in succession. If your setting is unsuccessful you will be prompted with 

one long tone.