Cisco Systems Gateway 10 Manuel D’Utilisation

To install the rack-mount brackets for a mid-mounted configuration on a Cisco RFGW-10 UEQAM, complete the following
steps:

Step 1

Locate the threaded holes on the middle sides of the chassis that align with the holes in the rack-mount bracket. Ensure
that you hold the front rack-mount bracket with the ear and holes facing outward and towards the rear of the chassis
(see Figure 6).

Step 2

Install all the six M5 undercut flat head screws (provided in the accessory kit) to secure each of the rack-mounting
bracket to the chassis. Three screws are installed on each end of the rack-mounting bracket.

Step 3

Repeat Step 1 through Step 2 on the other side of the chassis.

Step 4

Install the chassis in the rack. To install the Cisco RFGW-10 UEQAM in a rack, go to Installing the Cisco RFGW-10
UEQAM in a Rack, page 11.

Figure 6

Attaching the Rack-Mount Brackets for Mid-Mount Configuration to the Cisco RFGW-10 Chassis

Installing the Cisco RFGW-10 UEQAM in a Rack

After installing the rack-mount brackets, the installation handles on the chassis, and the installation brackets in the rack, mount
the chassis by securing the rack-mount brackets to the two posts or mounting strips in the rack. Because the rack-mount brackets
supports the weight of the entire chassis, be sure to use at least four rack-mount screws on each side to fasten the two
rack-mount brackets to the rack posts.

Cisco RFGW-10 Chassis

Rack-mount bracket

Rack-mount screws

273451