Silex Technology SX-550 Manuel D’Utilisation
Page 28
silex
Accessing Configuration Parameters
Part Number 40183-101
To send configuration data to the serial device, press the Test button on the SX-550 module. The
serial device should display or print the IP address assigned to the SX-550 module by your network
DHCP service.
serial device should display or print the IP address assigned to the SX-550 module by your network
DHCP service.
If your network does not use DHCP, then the SX-550 module will have the default IP address of
192.0.0.192.
192.0.0.192.
Note: When using the SX-550 module wirelessly, verify you are communicating using AdHoc mode
with the SSID configured as ‘serserv.’
with the SSID configured as ‘serserv.’
3. Enter the password. The default password is ACCESS. The SX-550 configuration home page
displays.
Figure 15 SX-550 Home Page
4. Continue to Chapter 6:
Setting Configuration Parameters.
Access Internal Command Console
You can access the Command Console by using the following methods:
• SX-550 Evaluation Daughtercard’s Ethernet port using a Telnet session
• SX-550 Evaluation Daughtercard’s serial port or console port using a terminal emulator