Server Technology Global Security Modem Manuel D’Utilisation

 

The CE mark is affixed to this product to confirm compliance with the following European Community 
Directives: 

•  Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of Member 

States relating to electromagnetic compatibility; and 

•  Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of 

Member States relating to electrical equipment designed for use within certain voltage limits; 
and 

•  Council Directive 1999/5/EC of 9 March on radio equipment and telecommunications 

terminal equipment and the mutual recognition of their conformity. 

1.    The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has 

accepted that the item complies with minimum conditions for connection to its network. It 
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. 
Above all, it provides no assurance that any item will work correctly in all respects with another 
item of Telepermitted equipment of a different make or model, nor does it imply that any product 
is compatible with all of Telecom’s network services. 
This equipment is not capable under all operating conditions of correct operation at the higher 
speed which it is designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower 
bit rates when connected to some PSTN implementations. Telecom will accept no responsibility 
should difficulties arise in such circumstances. 

2.    Immediately disconnect this equipment should it become physically damaged, and arrange for its 

disposal or repair. 

3.    This modem shall not be used in any manner, which could constitute a nuisance to other Telecom 

customers. 

4.    This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. 

There is no guarantee that Telecom lines will always continue to support pulse dialing. 
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may 
give rise to ‘bell tinkle’ or noise and may also cause a false answer condition. Should such 
problems occur, the user should not contact the Telecom Faults Service. 
The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing 
and is readily available on almost all New Zealand telephone exchanges. 

5.    Warning Notice: No ‘111’ or other calls can be made from this device during a mains power 

failure. 

6.    This equipment may not provide for the effective hand-over of a call to another device connected 

to the same line. 

7.  Some parameters required for compliance with Telecom’s Telepermit requirements are dependent 

on the equipment (PC) associated with this device. The associated equipment shall be set to 
operate within the following limits for compliance with Telecom’s Specifications: 
For repeat calls to the same number: 

•  There shall be no more than 10 call attempts to the same number within any 30-minute 

period for any single manual call initiation, and 

•  The equipment shall go on-hook for a period of not less than 30 seconds between the end 

of one attempt and the beginning of the next attempt. 

For automatic calls to different numbers: 

•  The equipment shall be set to ensure that automatic calls to different numbers are spaced 

such that there is no less than 5 seconds between the end of one call attempt and the 
beginning of another. 

•  For automatically answered incoming calls: 

•  The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of 

receipt of ringing. 

8.  For correct operation, total of the RN’s of all devices connected to a single line at any time 

should not exceed 5. 

Sentry Global Security Modem 

Appendices 

• 15 

Installation and Operations Manual