Siemens HC15 Manuel D’Utilisation
Getting Started with HC15
Confidential / Preliminary
s
HC15_startup_v01
Page 12 of 31
2007-01-22
2.5
Installed Devices and Tools
After successful installation, the devices listed below
are available. Under Windows XP, you can use the
Device Manager to check that all components are
properly installed and configured.
Siemens HSDPA USB Modem
• AT command and data interface, also referred to as “Modem” port if queried using the
are available. Under Windows XP, you can use the
Device Manager to check that all components are
properly installed and configured.
Siemens HSDPA USB Modem
• AT command and data interface, also referred to as “Modem” port if queried using the
AT^SQPORT command.
• Intended particularly for HSDPA and GPRS data connections.
• The virtual COM port Windows has assigned to the AT command and data interface is
listed in the Device Manager under Modems.
• The port number can be gathered from Control Panel | Phone and Modem Options. This
COM port can be used to set up dial-up network connections. The bit rate set by default
on the Modem property page is not relevant for USB and can be left unchanged. On the
Advanced tab you can put the command string used to define the PDP context for your
on the Modem property page is not relevant for USB and can be left unchanged. On the
Advanced tab you can put the command string used to define the PDP context for your
GPRS / HSDPA provider. See also Chapter
3.7.
3.7.