Siemens HC15 Manuel D’Utilisation
Getting Started with HC15
Confidential / Preliminary
s
HC15_startup_v01
Page 30 of 31
2007-01-22
5 Appendix
II
This chapter refers to the DSB75 Board and the adapter board needed to mount a HC15
module onto the DSB75 Board.
The focus is on the configuration of several switches you may be required to change for use
with HC15. A detailed description of the DSB75 Board is given in [3].
Please check that all slide switches (S100 – S103) on your HC15-DSB75 adapter board are
set as shown in Figure 3.
module onto the DSB75 Board.
The focus is on the configuration of several switches you may be required to change for use
with HC15. A detailed description of the DSB75 Board is given in [3].
Please check that all slide switches (S100 – S103) on your HC15-DSB75 adapter board are
set as shown in Figure 3.
Figure 3: HC15-DSB75 adapter board – switch settings
Figure 4 shows the DSB75 Board and provides an overview of the connectors and switches
relevant for HC15. Please note that the factory settings of the DSB75 Board are not fully
applicable to HC15. The switches marked red or yellow must be set as shown. The switches
marked green need not be changed.
X106, X107: Do not use
X104: 50-pin board-to-board
connector for HC15
X104: 50-pin board-to-board
connector for HC15
80-pin header