Philips KX-PNBC8 Manuel D’Utilisation

Windows NT 4.0 comes with TCP/IP and

 lpr capabilities but they must be installed 

when the unit is configured. You must install the TCP/IP Protocol, Simple TCP/IP 
Services, and Microsoft TCP/IP Printing prior to entering the network printer on the 
workstation. 

Note:

Once you have

 lpr installed on a Windows NT Server workstation and have 

allowed printer sharing, other workstations may use the printer through the 
Microsoft Windows Network without having to have separate

 lpr queues installed 

on each workstation.

The IP address, Subnet Mask and Default Gateway are required to be set for the 
Network Card. If the value can be set using the printer LCD panel, refer to 

When 

Setting by Direct Entering in Step 1 on 

This can be done with MAP if you have a NetWare connection on your network. Follow 
the instructions for these programs which are documented elsewhere. If you cannot 
use these programs, you can use the ARP procedure program.

1. Install the Network Card in your printer. 

2. Turn ON the printer. 

Note:

If you want to confirm the MAC ADDRESS after setting up the Network Card, print 
out the KX-P8415 Configuration Page.Instructions on how to print the 
Configuration Page, refer to the “KX-P8415 Setup Guide and Reference Guide”.
It should show that   TCP/IP is enabled but that the Protocol address is not 
configured.
If the unit already has an IP address, these procedures will not work. However, 
you can use the HTML pages accessed by MAP or Web Browser to change the IP 
parameters.