Network Technologies ASI-IP-GTW Manuel D’Utilisation
ASI-IP-GTW User's Manual
Page
17
GTW are no not blocked and allow at least 50 mm free air-space at
each side of the unit. The ASI-IP-GTW is designed to be stacked in
19"racks without ventilation panels between. In systems with
stacked units, it may be required to use forced-air cooling to reduce
the operating ambient temperature.
Figure 4 shows the air path through the unit.
each side of the unit. The ASI-IP-GTW is designed to be stacked in
19"racks without ventilation panels between. In systems with
stacked units, it may be required to use forced-air cooling to reduce
the operating ambient temperature.
Figure 4 shows the air path through the unit.
Figure 4. Air Path through the unit
2.2.6 To connect the equipment
Once the ASI-IP-GTW is installed in its intended operating position, it is
ready to be connected to the rest of the system. The following figure
shows the different equipment connections.
ready to be connected to the rest of the system. The following figure
shows the different equipment connections.
Figure 5. Signal connections
Remove mains supply previous to move or install the equipment.
Ensure ESD precautions are observed whilst interconnecting
equipment.
1.1.1.9 ASI port
The ASI-IP-GTW can be operated in three modes: IP Transmit, IP
Receive, and IP bi-directional mode.
In IP transmit mode, the equipment receives up to 8 DVB-ASI streams
and sends them to the IP network. In this mode, connect the individual
DVB-ASI input signals to the connectors marked with ASI. If you have
ordered the unit with less than 4 ASI ports, the enabled ports starts at
number 1 up to the number of ports ordered.
In IP receive mode, the equipment receives an IP stream and sends the
individual MPEG-2 transport streams out on the DVB-ASI connectors.
In this mode, connect the DVB-ASI output to the input of the
equipment to receive MEG-2 transport stream from the unit. If you
The ASI-IP-GTW can be operated in three modes: IP Transmit, IP
Receive, and IP bi-directional mode.
In IP transmit mode, the equipment receives up to 8 DVB-ASI streams
and sends them to the IP network. In this mode, connect the individual
DVB-ASI input signals to the connectors marked with ASI. If you have
ordered the unit with less than 4 ASI ports, the enabled ports starts at
number 1 up to the number of ports ordered.
In IP receive mode, the equipment receives an IP stream and sends the
individual MPEG-2 transport streams out on the DVB-ASI connectors.
In this mode, connect the DVB-ASI output to the input of the
equipment to receive MEG-2 transport stream from the unit. If you