OKI 3100e Manuel D’Utilisation
English
Chapter 4 - Administrating Network Printers
59
Setting TCP/IP
To use this network card in the TCP/IP protocol, TCP/
IP must be set to ENABLE on the printer’s operator
panel.
IP must be set to ENABLE on the printer’s operator
panel.
TCP/IP enable/disable
1.
Confirm that the printer is in the idle state from
the LCD panel and the indicator.
the LCD panel and the indicator.
2.
Press ON-LINE button to set the printer to OFF-
LINE and hold the MENU1 button for 2 seconds
or longer to have PRINT MODE displayed.
LINE and hold the MENU1 button for 2 seconds
or longer to have PRINT MODE displayed.
3.
Press the
MENU1 button repeatedly until
NETWORK displayed, and press the ENTER
button.
button.
4.
When you see that the bottom column of the LCD
of TCP/IP is ENABLE*, press MENU1 button to
proceed to set IP BYTE1. If the bottom column
of the LCD is DISABLE*, press left arrow button
or right arrow button until ENABLE is displayed
in the LCD bottom column. Then press the
ENTER button to have ENABLE* displayed (*
indicates that value is set.)
of TCP/IP is ENABLE*, press MENU1 button to
proceed to set IP BYTE1. If the bottom column
of the LCD is DISABLE*, press left arrow button
or right arrow button until ENABLE is displayed
in the LCD bottom column. Then press the
ENTER button to have ENABLE* displayed (*
indicates that value is set.)
Setting IP address
1.
Following the procedure of “TCP/IP enable/
disable” above, press MENU1 button until IP
BYTE1 is displayed.
disable” above, press MENU1 button until IP
BYTE1 is displayed.
2.
Change the address by pressing left arrow button
or right arrow button. (If you hold the button for a
several seconds, it will expedite the address
updating.) When the value to be set is displayed,
press the ENTER key to finalize it.
or right arrow button. (If you hold the button for a
several seconds, it will expedite the address
updating.) When the value to be set is displayed,
press the ENTER key to finalize it.
3.
Press MENU1 button to move to IP BYTE2
setting. You can set up to and including IP
BYTE4 using the same procedure above as for IP
BYTE1.
setting. You can set up to and including IP
BYTE4 using the same procedure above as for IP
BYTE1.
Setting subnet mask
1.
Following the procedure of “Setting IP address”
above, press MENU1 button until SM BYTE1 is
displayed.
above, press MENU1 button until SM BYTE1 is
displayed.
2.
Change the address by pressing left arrow button
or right arrow button. (If you hold the button for a
several seconds, it will expedite the address
updating.) When the value to be set is displayed,
press the ENTER key to finalize it.
or right arrow button. (If you hold the button for a
several seconds, it will expedite the address
updating.) When the value to be set is displayed,
press the ENTER key to finalize it.
3.
Press MENU1 button to move to SM BYTE2
setting. You can set up to and including SM
setting. You can set up to and including SM
3100euGB.book Page 59 Friday, March 16, 2001 1:18 PM