Nortel Networks BSG12ew Manuel D’Utilisation
Installation options 43
Installation
Installing the BSG8ew/12ew/aw/tw on top of another unit
Use this procedure to install a BSG8ew/12ew/aw/tw on top of a BCM50 or BES50 in a desktop or
rack-mount installation.
rack-mount installation.
Procedure steps
Step
Action
1
If installing the BSG8ew, insert the power supply retention clip.
The BSG12ew/aw/tw uses a different power connector, which does not require
a retention clip.
a retention clip.
2
Place the BSG8ew/12ew/aw/tw on top of a BCM50 or BES50. If the rubber feet
are installed, remove them. Make sure the feet of the BSG8ew/12ew/aw/tw are
in the slots on the top of the other unit and in front of the slots as shown in the
following figure.
are installed, remove them. Make sure the feet of the BSG8ew/12ew/aw/tw are
in the slots on the top of the other unit and in front of the slots as shown in the
following figure.
3
Slide the unit back until it clicks in place on the slots.
End
Slots
Feet