Nortel Networks 201i Manuel D’Utilisation
About the 201i server
Standard 1.07
28
CallPilot
Network requirements
Appropriate networking equipment must be available for both the CLAN
and ELAN.
Appropriate networking equipment must be available for both the CLAN
and ELAN.
The CLAN and ELAN must be properly configured for correct CallPilot
operation. To ensure correct configuration, Nortel recommends that you
consult a network specialist.
operation. To ensure correct configuration, Nortel recommends that you
consult a network specialist.
Multi I/O cable description
The multi I/O cable contains four connectors, and is approximately 3 m
(10 ft) in length. See the following diagram:
(10 ft) in length. See the following diagram:
ATTENTION
For important considerations about using the ELAN in
your network, see “About the ELAN” in the CallPilot
Installation and Configuration Task List.
your network, see “About the ELAN” in the CallPilot
Installation and Configuration Task List.
G101441
RS-232
connector
connector
RJ-45 female-to-female gender change jack
Note: If you need more than 3 m (10 ft) of multi I/O cable, use the supplied RJ-45
female-to-female gender change jacks to attach additional cable. A maximum of
76.2 m (250 ft) is supported.
female-to-female gender change jacks to attach additional cable. A maximum of
76.2 m (250 ft) is supported.
ELAN
connector
connector
CLAN
connector
connector
Drain wire
50-pin
amphenol
connector
amphenol
connector
Multi I/O cable NTRH0912