Nortel Networks 201i Manuel D’Utilisation

Installing the 201i server in a large Meridian 1 system

Standard 1.07

56

CallPilot

The 201i server occupies two slots. You can install the 201i server in slots 
0 through 14. Ensure that both slots have electrical backplane connectivity.

1 Ensure that no cables are connected to the slots in which you are 

installing the 201i server.

2 Open the lock latches at the top and bottom of the 201i server faceplate.

Note: When you open the top lock latch, you break the yellow backplane 
warning label, if it has not been removed. You must move the secondary 
backplane connector before you install the 201i server. For details, see 
“Repositioning the secondary backplane connector” on page 50.

3 Slide the 201i server into an unoccupied pair of slots.

Ensure that the 201i server is positioned correctly between the slots. 

4 Connect the low-profile right-angle SCSI cable connector to the SCSI 

connector on the 201i server faceplate.

Do not push the 201i server into place against the 
backplane until you are ready to observe the startup 
cycle.

The 201i server receives power and starts as soon as 
the 201i server makes contact with the switch 
backplane.