Nortel Networks 4050 Manuel D’Utilisation

Chapter 10 Configuring system settings 469

Nortel Secure Network Access Switch 4050 User Guide

 

To view the host number and IP address for each Nortel SNAS 4050 device in the 
cluster, use the 

/cfg/sys/host <host ID>/cur

 command.

The default IP interface on the Nortel SNAS 4050 host is Interface 1. You can 
create additional interfaces and specify the ports to be assigned to each interface. 
If you assign more than one port to an interface, you can choose whether the ports 
will operate in failover or trunking mode.

You can create a maximum of four interfaces on each Nortel SNAS 4050 host.

To configure an IP interface and the assignment of physical ports on a particular 
Nortel SNAS 4050 host, use the following command:

/cfg/sys/host <host ID>/interface <interface ID>

where 

 is an integer in the range 1 to 252 that uniquely identifies 

the interface on the Nortel SNAS 4050 host. To configure a new interface, enter an 
unused interface ID number. To change the configuration of an existing interface, 
enter the applicable interface ID number.

The Host Interface menu displays.

The Host Interface menu includes the following options:

/cfg/sys/host #/interface <interface ID>

followed by:

ip <IPaddr>

Sets the network address for the interface. (For 
Interface 1, the network address is the RIP.)

netmask <mask>

Sets the subnet mask for the interface.