Nortel Networks 4050 Manuel D’Utilisation
Chapter 16 The Command Line Interface 771
Nortel Secure Network Access Switch 4050 User Guide
Requirements
To establish a console connection with the Nortel SNAS 4050, you need the
following:
following:
•
An ASCII terminal or a computer running terminal emulation software set to
the parameters shown in
the parameters shown in
•
A serial cable with a female DB-9 connector. For more specific information,
see the chapter about connecting to the Nortel SNAS 4050 in Nortel Secure
Network Access Switch 4050 Installation Guide (320846-A).
see the chapter about connecting to the Nortel SNAS 4050 in Nortel Secure
Network Access Switch 4050 Installation Guide (320846-A).
Procedure
1
Connect the terminal to the Console port using the correct serial cable.
When connecting to a Nortel SNAS 4050, use a serial cable with a female
DB-9 connector (shipped with the Nortel SNAS 4050).
DB-9 connector (shipped with the Nortel SNAS 4050).
2
Power on the terminal.
3
To establish the connection, press ENTER on your terminal.
You will next be required to log on by entering a user name and a password. For
more information on user accounts and default passwords, see
more information on user accounts and default passwords, see
Table 174
Console configuration parameters
Parameter
Value
Baud rate
Data bits
Parity
Stop bits
Flow control
9600
8
None
1
None