Star Micronics IS-NP192 Manuel D’Utilisation
6
Switch 2: Parity Check
This switch specifies whether or not a parity check should be performed
on the data.
on the data.
Parity Check
SW2
DOS Setting
Disabled
ON
Disabled
Enabled
OFF
Enabled
Switch 3: Parity
This switch specifies the parity as non, odd, or even.
Parity
SW3
DOS Setting
Odd
ON
O
Even
OFF
E
Switch 4: Protocol
Protocol, which is sometimes referred to as “handshaking,” is the com-
munications convention that is used to allow the printer and computer
to regulated the flow of data. DTR is the most commonly used proto-
col.
munications convention that is used to allow the printer and computer
to regulated the flow of data. DTR is the most commonly used proto-
col.
Protocol
SW4
DOS Setting
DTR
ON
DTR
XON/XOFF
OFF
XON/XOFF
Switches 5, 6: Not used
BANK B
Switch 1, 2, 3: Baud Rate
The baud rate is the speed, in bits per second, that the printer sends
data to the computer. The common setting is 9600 or 19200.
data to the computer. The common setting is 9600 or 19200.