Telenetics 56 Manuel D’Utilisation
AT Commands
Page 113
AT&F Restore Factory Defaults
Your modem comes with factory default settings for all communications settings and S Registers.
The &F command enables you to restore the factory default values to the command settings and
S Registers. This command does not reset stored phone numbers, security, or encryption
settings.
The &F command enables you to restore the factory default values to the command settings and
S Registers. This command does not reset stored phone numbers, security, or encryption
settings.
The &F1 command selects non-error correction factory defaults. The defaults selected are:
X0 &K0 &D2 \N1 %C0
The &F2 command selects synchronous mode factory defaults. The defaults selected are:
B13 E0 Q1 &M2
You must use the &W command if you wish to save the default values to nonvolatile memory,
and thus preserve these values when you switch the modem off.
and thus preserve these values when you switch the modem off.
☞
☞
☞
☞
☞
If you issue the &F command while the modem is off-hook, an ERROR message
will be returned.
will be returned.
Options
AT&F0
Restore Command and S Registers to Factory Defaults
AT&F1
Select non-error correction factory defaults
AT&F2
Select synchronous mode factory defaults
See Also
&V command
View the Active Configuration
Z command
Restore Configuration
&W command
Save Configuration