LSI 1600 Manuel D’Utilisation

          MegaRAID Enterprise 1600 Hardware Guide

Installation Overview During installation, some nodes are shut down, and other nodes are rebooted. This is

necessary to ensure uncorrupted data on disks attached to the shared storage bus. Data corruption
can occur when multiple nodes try to write simultaneously to the same disk, if that disk is not yet
protected by the cluster software.

The table below shows which nodes and storage devices should be powered on during each step.

Set Up Networks

On

On

Off

Make sure that power to all storage devices on
the shared bus is turned off. Power on all nodes.

Set up Shared Disks

On

Off

On

Power down all nodes. Next, power on the shared
storage, then power on the first node.

Verify Disk Configuration Off

On

On

Shutdown the first node. Power on the second
node.

Configure the First Node

On

Off

On

Shutdown all nodes. Power on the first node.

Configure the Second
Node

On

On

On

Power on the second node after the first node was
successfully configured.

Post-installation

On

On

On

All nodes should be active.

Before installing the Cluster Service software you must follow the steps below:

•  Install Windows 2000 Advanced Server or Windows 2000 Datacenter Server on each node

•  Setup networks

•  Setup disks

Note: 

These steps must be completed on every cluster node before proceeding with the installation of
Cluster Service on the first node.

To configure the Cluster Service on a Windows 2000-based server, you must be able to log on as
administrator or have administrative permissions on each node. Each node must be a member
server, or be domain controllers inside the same domain.  A mix of domain controllers and member
servers in a cluster is not acceptable.