Emerson FPC Manuel D’Utilisation

NOTE
Read the entire manual before installing or operating the system.

The shipping bands may be under tension. Use appropriate eye, face, and hand protection to 

safeguard against injury from band backlash.

Verify that all incoming line voltage (power) and low-voltage (control) circuits are

de-energized and locked out before installing cables or making connections, whether in the 

junction box or in the unit.
Equipment inspection and start-up should be performed only by trained personnel. Lethal 

voltages are present during start-up procedures. Electrical safety precautions must be 

followed throughout inspection and startup.
Only qualified service personnel should perform maintenance on the Liebert FPC system. All 

voltage sources to the unit must be disconnected before inspecting or cleaning within the 

cabinet.
Lethal voltages exist within the equipment during operation. Observe all warnings and 

cautions in this manual. Failure to comply may result in serious injury or death. Obtain 

qualified service for this equipment as instructed.
The monitoring system contains a lithium battery for memory backup. There is a danger of 

explosion if battery is incorrectly replaced. Replace only with same or equivalent type. 

Dispose of used batteries according to the manufacturer’s instructions.

NOTE 
The unit should not be loosened from the shipping pallet until all handling by fork lift or pallet