RAD Data comm RIC-155 Manuel D’Utilisation

 

Configuring RIC-155 

1 

Installation of RIC-155 should be carried out only by an experienced technician. If 
you are familiar with RIC-155, use this guide to prepare the units for operation. 

1.  Connect the STM-1/OC-3c equipment to the fiber optic or BNC rear panel 

connectors.  

2.  Connect the 10/100BT LAN to the DATA rear panel connector. 
3.  Use a cross cable to connect the control terminal to the rear panel CONTROL 

connector. 
or 
Connect a Telnet host, a PC running a Web browsing application or a 
RADview management station to the MNG port. 

•  Connect the power cable to the power connector on the RIC-155 rear panel. 

The unit has no power switch. Operation starts when the power is applied 
to the rear panel power connector(s). 

Configure RIC-155 to the desired operation mode via an ASCII terminal connected to 
the rear panel CONTROL port. Alternatively, you can manage RIC-155 over Telnet, a 
PC running a Web browsing application or RADview application via the MNG port. 

 

To start a terminal session: 
1.  Connect a terminal cross-cable to the CONTROL connector of RIC-155. 
2.  Start a terminal application and configure the terminal link as follows: 

 

Terminal emulation – VT100 

 

Screen width – more than 80 characters. 

3. Power RIC-155 up. 

The SIG LED (green) blinks during software extraction and hardware 
initialization.