RAD Data comm IPmux-1E Manuel D’Utilisation

IPmux-1/1E Installation and Operation Manual

Appendix E Parameters and Screens

LAN Configuration (no User port)

E-27

E.8 LAN Configuration (no User port)

For LAN configuration for two LANs, see Ethernet Configuration/Statistics Menus.

LAN CONFIGURATION

1. Auto Negotiation Enable

2. Max Capability advertised 100baseT Full Duplex

3. Default type 100baseT Full Duplex

ESC. Exit

Select item from the menu.

Figure E-27. LAN Configuration Menu

Table E-19. LAN Configuration Parameters

Parameter Possible

Values

Remarks

Auto Negotiation

Enable, Disable

Auto Negotiation mode is according to RFC 2239
Default: Enable

Maximum Capabilities
Advertised

Maximum Capabilities of the port for the Auto
Negotiation process (can be lower then the actual
capabilities)
Default: 100baseT Full Duplex

Default Type

10BaseT Half Duplex,
10BaseT Full Duplex,
100BaseT Half Duplex,
100BaseT Full Duplex

Default: 100baseT Full Duplex
Note: This parameter is valid only when the Auto
Negotiation mode is disabled (RFC 2239).

If Auto Negotiation is set to Enable and you experience some incompatibility in the

Auto Negotiation process, set Auto Negotiation to Disable and set Default type to

the desired mode.

When the physical port is fiber, the operation mode is:

Auto Negotiation Off//full duplex/100 Mbps. This is the only possible setting.

Main Menu
↓

2. Configuration
↓

4. LAN

Configuration

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610