Quantum Audio 3A Series Manuel D’Utilisation

Rack Mounting the Autoloader

Rack Mounting the Autoloader

This section provides the steps for attaching the autoloader directly to the stationary rails 

of a rack. Refer to 

 for information on common rack hole types.

Table 1   Rack Hole Types

Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the rack, 

making sure that you install each pair of clip nuts at exactly the same level (see 

).

Square rack holes are the most 
common type of rack holes. 
They can accept either cage 
nuts which mount from the back 
of the rail or clip nuts which clip 
on from the side of the rack rail.

Through holes require clip nuts 
to accept mounting hardware.

Threaded holes require neither 
cage or clip nuts to accept 
mounting hardware.

The rails within the rack have a hole pattern that repeats throughout the rail.