RAD Data comm ASMi-31 Manuel D’Utilisation

ASMi-31 Installation and Operation Manual

Chapter 5. Card Cage Version

16-03-00 15:51

Installing ASMi-31/R

5-5

5.4 Installing ASMi-31/R

➤

➤ To install the ASMi-31/R card in the ASM-MN-214 card cage:

1. Install the ASM-MN-214 card cage in the 19" rack.
2. Adjust the jumpers and switches on the card as required (see Figure 2-

1 and Table 2-1 in Chapter 2).

3. Insert the ASMi-31/R card into one of the ASM-MN-214 slots. Push the

bottom of the card into the cage to until it is fully inserted into the edge
connector inside the rack. Tighten the screws on the top and on the
bottom of each card.

4. Remove the protection cover from the terminal block connectors.
5. Connect the terminal block to the ASM-MN-214 terminal block

connector.

6. Connect the line to the terminal block as follows: connect transmit pair

to the terminals marked XMT, the receive pair to the terminals marked
RCV, and the fifth screw to ground (optional).

7. If required, attach the appropriate CIA (CIA/X.21 or CIA/V.35/1) or V.36

adapter cable to the DB-25 connector on the card cage rear panel.

8. Connect the DTE cable to the DB-25 connector, other side of CIA or

adapter cable (depending on your version of the card interface).

9. Connect power to the ASM-MN-214 card cage:

•

To connect AC power, connect the power cable to the mains supply.

•

To connect DC power, refer to DC Power Supply Connection
Supplement of the ASM-MN-214 manual.

Warning

The ASM-MN-214 card cage has no power switch. Operation starts

when the power is applied to the rear panel POWER connector. When

applying power, first connect the plug of the power cord to the

ASM-MN-214 POWER connector and then to the mains power source

(outlet).

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610