Zhone Technologies Z-PLEX-10-24-DOC-SC Manuel D’Utilisation
4-2 \
Zhone Technologies
Model No.
Running Head
Quick start system configuration
Configuring the Z-Plex
SET T1CFG:STATE:1:ACTV
To read the current frame slips on the first T1 line, enter the following command:
GET PMCUR:SLIP:1
Keep in mind the following important information:
•
The CLI is case sensitive.
•
Keywords must be entered completely. There are no keyboard shortcuts.
•
The backspace and delete keys are supported.
•
Command history is supported.
For complete information about the CLI parameters and syntax, see Appendix A, “Alphabetic
Reference.”
Reference.”
4.2
Quick start system configuration
You must perform the initial configuration of the system via the serial (craft) interface. After
you have completed the initial configuration, you can manage the Z-Plex unit using any of the
methods described in “Configuring a management interface” on page 4-4.
you have completed the initial configuration, you can manage the Z-Plex unit using any of the
methods described in “Configuring a management interface” on page 4-4.
To access the serial port, you must configure your terminal interface software with the
following settings:
following settings:
•
9600bps
•
8 stop bits
•
No party
•
1 data bit
After the system boots up, perform the following procedures from the serial interface:
1. Log into the system (the default user name is “user”, the default password is “password”):
login> user
login> ********
user>
2. Assign the system an IP address and a netmask. For example:
user> SET CPUCFG:MASK:1:255.255.255.252
user> SET CPUCFG:IP:1:192.168.8.21