Renesas M30620T-CPE Manuel D’Utilisation

(3) Remove the oscillator

Figure 3.4 shows the position of the oscillator for the main clock. Remove the oscillator using
a soldering iron. Be careful not to break the other part.

(6) Check the operation of the system

After connecting the target system, start up the emulator system. If the emulator starts up
normally, the replacement is completed.

(4) Connecting the Oscillator

Solder the included 16MHz oscillator in the place of the older oscillator (see Figure 3.4).
Solder the oscillator so that the label can be read.

(5) Connecting the target connection board

Check the oscillator is properly connected. If it is, connect the target connection board to the
emulator. The connectors are designed so that they cannot be inserted in the opposite
direction, therefore check orientation before inserting the oscillator. Also, insert the oscillator
without applying excessive force.

Insert an equal amount of force to the connectors on each end of the target connection board when inserting the board.
Note: Do not insert excessive force to the connectors. Excessive force can break the connectors.

• When a 16MHz oscillator is installed, the self-check cannot be executed, because it

must be done with the target system not connected. During standalone operation, the
emulator operates at 3.3 V, which exceeds the guaranteed operating frequency of the
MCU.

Oscillator for
main clock