Honeywell DCP552 Mark II Manuel D’Utilisation

The 

is a general purpose dual-loop control programmer for controlling temperature, pressure, flow rate,

carbon potential (CP) and other parameters. The program provides a total of 49 patterns and up to 99 segments can

be set for each pattern. Note, however, that the maximum number of segments is 2000 or less and that the

maximum number of subfunctions for setting events is 4000 or less.

●

Featuring a multi-range format, the user can select thermocouple, resistance

temperature detector, DC voltage or DC current. Accuracy is ±0.1% FS ±1 digit,

the sampling cycles is 0.1 sec and some model numbers allow PV2 channel O

2

sensor inputs for carbon potential compensation.

●

Selection at setup allows the user to choose from among current proportional

output, voltage time proportional output and open collector time proportional

output.

●

Selection at setup enables the user to switch between RS-485 and RS-232C on the

rear panel terminal base.

At setup it is also possible to switch the communications port from the rear panel

terminal base to the front panel loader jack. A special cable is required to use to

loader jack on the front panel.

●

The programmer is equipped with 16 external switch inputs and 16 event outputs

for flexible support of PLC based automatic systems.

●

The optional plug-in memory card makes it easy to achieve program and

parameter settings for later reuse. Also, the optional smart loader package allows

you to make program and parameter settings from a PC.