Honeywell DCP552 Mark II Manuel D’Utilisation

Programming is enabled in the normal display mode. When the 

is not in the normal mode display, press

the 

to invoke it. Programming is simpler if you set down the objectives of the program on a program

work sheet before you start programming.

For ease of use, please enlarge the copy of the 

located after page 12-18.

■

Numbers can be selected in one of two ways.

•

before programming

•

during programming

●

Press the 

in the normal display mode in the READY mode. When the

program number starts flashing, use the 

or the 

↑, ↓, ←, or →

to

select a number.

Program numbers cannot be selected during external switch input.

See “Section 6-3 Selecting Programs” (page 6-11) for details.

●

Press the 

and 

in program setting state so that the program

number starts to flash. Use the 

↑, ↓, ←, or →

to make the desired changes

and press the 

to enter them. Note, however, that you must after

exiting the registration state (when set values flash) with the 

, press

the 

and 

. When programs are selected in this way, the pattern

items are displayed on the programming map.

This allows you to select a program number of a program other than the one

processed in the RUN mode. It also allows you to select the number of another

program using the external switches.

■

Channels can be selected in one of two ways.

• before programming

• during programming

●

Press the 

and 

in the normal display mode to change channels.

●

Press the 

and 

in the program setting mode, to change

channels. The system is set to the program setting mode for a different channel

with the same program number and the pattern item in the first segment is

displayed.