ZyXEL Communications ZyXEL AG-220 Manuel D’Utilisation
ZyXEL AG-220 User’s Guide
74
Chapter 5 Access Point Mode Configuration
5.1.2 Additional Setup Requirements
To bridge your wired and wireless network using the AG-220, the following requirements
must be met:
must be met:
1 The AG-220 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to
sharing (refer to
for an example).
3 Set the wireless station’s IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the AG-220. Refer to
for how to configure your computer’s IP address.
5.2 The Link Info Screen
Select the AP Mode check box and wait for about five seconds to display the screen as shown.
Figure 50 Access Point Mode: Link Info
The following table describes the labels in this screen.
Table 18 Access Point Mode: Link Info
LABEL
DESCRIPTION
Status
SSID
This field displays the name that identifies your AG-220 in the wireless LAN
network.
Current Channel
This field displays the radio channel the AG-220 is currently using.
Transmission Rate This field displays the current transmission rate of the AG-220 in megabits per
second (Mbps).