Acer 08P4100 Manuel D’Utilisation

Installing Solaris Using the Solaris Device Configuration Assistant Diskette

7-4

PCI Disk Array Controller Drivers Manual

10. Press <F2> to continue.



DO NOT REMOVE the Solaris Device Configuration 
Assistant Diskette from the disk drive until you see 
the following message displayed in a dialog box:

Message: If you want to bypass the device 
configuration and boot screens when the system 
reboots, eject the Solaris Device Configuration 
Assistant/Boot diskette now.

11. Continue with Sun Microsystems’ installation instructions and follow 

the screen prompts. 

12. Near the end of the Solaris operating system installation, you will be 

asked to insert the Mylex Supplemental Driver. Insert the diskette at 
that time. 

The system will automatically reboot when the Solaris operating 
system has been completely installed. 

Before you begin to add or update your drivers, check that your newly 
supported hardware devices are installed and configured according to the 
instructions in the corresponding Device Reference Page, if any. See Device 
Reference Manual for Solaris (Intel Platform Edition).

These instructions assume that you are working with a x86 system using 
either the Mylex MDAC driver.

☛

When the Solaris Intel Platform Edition software is 
already installed, the simplest way to add new or 
updated drivers is to install the supplemental driver 
diskettes as patches on your system.

Follow the steps below for a secondary (existing) installation.