ADC P-90-250 Manuel D’Utilisation



 1996, ADC Telecommunications, Inc.

8993-A

2.07 The cable clamp kits (

) are installed on-site to separate the incoming OSP

cable fibers for easier management within the wall box. Each cable clamp kit includes a
mounting plate (upper or lower; i.e., high or low), a clamp cover plate, two rubber yokes, a set of
five rubber grommets, and associated hardware (two mounting screws and two clamp screws).

Note: The breakout lengths of the OSP cable fibers should be long enough to extend
2.5 times around the radius limiters that surround the splice tray.

1. Mount the selected cable clamp mounting plate (either high or low) using two

.

2. Select a grommet which (when placed around the cable), has a gap within the range of

nearly zero to 0.30 inch (0 to 8 mm). If the outer diameter of the cable is 0.7 to 0.8 inch
(1.78 to 2.03 cm), no grommet is required.

3. Assemble the cable clamp components as shown in 

: secure the cable and

grommet (if used) between the two cable clamp yokes, then place the clamp plate over
the outer yoke and secure the yokes and cable to the mounting plate with two long
screws. Be sure the cable sheath extends approximately 0.75 inch (1.9 cm) beyond the
cable clamp.

4. Repeat steps 1 through 3 as necessary to install additional cable clamp kits.