ADC MM702G2 Manuel D’Utilisation

Chapter 4: Configuring the WAN

4-2

You can configure up to 32 total PPPoA, PPPoE, 1483-Bridge, and 1483-Router sessions for the modem. See page 
25 for the maximum number of sessions per each protocol type that can be set up. A default bridging session is set 
up. From the WAN configuration page (

), define the parameters for each session.

1

Select WAN on the menu bar to access the WAN Configuration page.

2

To add a new session, choose one of the following protocols from Select a new session type.

• RFC 1483 bridged if the modem forwards packets based on MAC addresses. You can enable Span-

ning Tree when you select Bridge sessions. See 

• RFC 1483 routed if the modem routes packets based on IP addresses.

• PPPoA routed if the modem establishes PPP sessions over ATM with the service provider and routes

packets based on IP addresses.

• PPPoE routed if modem establishes PPP sessions over Ethernet with the service provider and routes

packets based on IP addresses.

3

Click Configure to access the session page for the protocol type you selected.

4

Go to the appropriate section that follows for the protocol that you selected.

F4 and F5 OAM are enabled on default PVCs (0/35 and 0/100) and on every new PVC that is created.