ADC SG-1 Manuel D’Utilisation
3-1
3
Chapter
C
OMMAND
-L
INE
I
NTERFACE
(CLI)
This chapter describes the SG-1 Command-Line Interface (CLI), the steps to access the CLI, and the steps to
perform initial configuration using the CLI.
perform initial configuration using the CLI.
O
VERVIEW
The SG-1 Service Gateway System management interface is accessed using a CLI, which provides comprehensive
SG-1 system management including configuration, performance monitoring, and system maintenance and
administration. An SG-1 Service Gateway System comprises an SG-1 10U Chassis with associated Service
Creation Cards (10/100 SCC, GiG-E SCC, ATM/GiG-E SCC) and rear I/O cards.
SG-1 system management including configuration, performance monitoring, and system maintenance and
administration. An SG-1 Service Gateway System comprises an SG-1 10U Chassis with associated Service
Creation Cards (10/100 SCC, GiG-E SCC, ATM/GiG-E SCC) and rear I/O cards.
The command-line interface is accessed through the SCC (or rear I/O card if installed) COM port using either a
terminal connected directly to the COM port or over a network using a Telnet session. You can connect your Telnet
session from:
terminal connected directly to the COM port or over a network using a Telnet session. You can connect your Telnet
session from:
• A PC connected on the SG-1 Ethernet Local Area Network (LAN).
OR
• A remote PC connected over a router to the SG-1 Ethernet port.
This chapter provides an introduction to the command-line interface structure and then provides information on how
to use it.
to use it.
U
NDERSTANDING
THE
I
NTERFACE
S
TRUCTURE
The command-line interface has four system management menus for administration, configuration, display, and
diagnostics.
diagnostics.
These four system management menus comprise four sub-menus (Configuration, Main, Debug, and Configuration-
Debug).
Debug).
provides a description of these sub-menus and their associated commands.
Table 3-1. SG-1 Sub-Menus and Associated Commands
Menu
Types of Commands
Configuration
Use the commands in this second level menu to configure:
• port configuration
• system passwords
• default authentication service type
• RADIUS parameters
• ACL permissions
• Tunnel server parameters
• ATM parameters
• PPP and LCP configuration
• service parameters
• system parameters
• native IP parameters
• VRRP parameters
• IP parameters
• debug message levels
• system passwords
• default authentication service type
• RADIUS parameters
• ACL permissions
• Tunnel server parameters
• ATM parameters
• PPP and LCP configuration
• service parameters
• system parameters
• native IP parameters
• VRRP parameters
• IP parameters
• debug message levels
Main
Use the commands in this menu to access other command levels and perform
system updates, system reloading, and network troubleshooting.
system updates, system reloading, and network troubleshooting.