ADC 410F Manuel D’Utilisation
Using the RS-232 management Port for Set Up
24
Megabit Modem 410F and 420F User Manual
U
SING THE
RS-232
MANAGEMENT
P
ORT FOR
S
ET
U
P
You can configure some parameter for the Megabit Modem 410F and 420F modems through
the RS-232 port that is connected to a PC. You can use the Megabit Modem Setup Menu to do
the following:
the RS-232 port that is connected to a PC. You can use the Megabit Modem Setup Menu to do
the following:
•
manually change the LAN and WAN IP address and network mask
•
enable Dynamic Host Configuration Protocol (DHCP)
•
configure modem parameters (these are a subset of the parameters that can be configured
using the Megabit Modem 410F and 420F Web pages)
using the Megabit Modem 410F and 420F Web pages)
Pairgain Megabit Modem 410F Setup Menu
========================================================
BSP version:
2.2
SW version:
2.8
========================================================
(1)Enter LAN IP address:
192.168.0.1
(2)Enter LAN IP network mask:
255.255.255.0
(3)Toggle Bridging:
Enabled
(4)Toggle Routing:
Disabled
(5)Toggle LAN DHCP:
Disabled
(6)Toggle Spanning Tree:
Enabled
(7)Enter WAN IP address:
(8)Enter WAN IP network mask:
(9)Toggle LAN RIP:
Enabled
(10)Toggle WAN RIP:
Enabled
(11)Enter default gateway IP address:
0.0.0.0
(12)Enter IP Admin address:
0.0.0.0
(13)Set Factory Defaults
(14)Reset modem
>