ADC H2TU-C-231 Manuel D’Utilisation
LTPH-UM-1109-01, Issue 1
Provisioning
H2TU-C-231 List 2
January 9, 2002
13
P
ROVISIONING
T
ASKS
After H2TU-C-231 is successfully installed, perform these basic provisioning tasks.
•
Set date and time (see
below)
•
Set circuit ID numbers (see
)
•
Make any necessary configuration changes (see
)
•
Clear history, alarm, and event log screens to remove miscellaneous data during startup (see
Setting Date and Time
Figure 4.
Config Menu - Date and Time
1
Press
to select the Config menu.
2
Use the
and
arrow keys to select Date and Time, then press
.
3
Type the date in the format indicated, then press
.
Rlogon/Rlogout
Remote logon can be performed from the H2TU-C or H2TU-R. The screen displays “Rlogout”
when the H2TU-C or H2TU-R is remotely logged on to the other unit at the end of the circuit.
when the H2TU-C or H2TU-R is remotely logged on to the other unit at the end of the circuit.
Remote logon from the H2TU-C will permit viewing of the H2TU-R and BERT Signal
Generator configuration submenu.
Generator configuration submenu.
To log off from the remote unit, press
. “Rlogout” changes to “Rlogon”. The unit is now
locally logged on until
is pressed again to re-initiate the remote logon.
Help
Provides a glossary of terms used in the maintenance screens, a list of navigational keys, and
ADC contact information.
ADC contact information.
Table 4.
Logon Screen Menus (Continued)
Press this
key:
key:
To access this
menu:
menu:
Menu Functions
R
R
R
H
Monitor
Performance
Event Log
Config
Inventory
Report
Rlogon
Help
+----------------------+
| Standard Options ->
| Standard Options ->
|
| ADC Options
->
|
| BERT Generator
->
|
|
Date and Time
->
|
+-------------------------------+
| Date (mm/dd/yyyy):
| Date (mm/dd/yyyy):
05/15/2001
|
| Time (hh:mm[:ss]): 12:30:01
|
+-------------------------------+
ID: xxxx--xxxx—-xxxx--xxxx
09/01/2001 12:30:01
H2TU-C
System: OK
___
C
↑
↓
ENTER
ENTER