Compatible Systems 1200i Manuel D’Utilisation

Appendix C - LED Patterns and Test Switch Settings

Appendix C - LED Patterns and
Test Switch Settings

MicroRouter 1200i LED Patterns

The MicroRouter 1200i uses a number of light patterns on its front LED
bars to indicate operating conditions.

Power On, No Traffic

The router will scan through the left (Ethernet) LED bar, from left to
right, illuminating one element at a time.

Note:

Lights 1 and 10 on the Ethernet bar are directly connected to

the router’s 10BaseT interface and indicate 10BaseT link (1) and
10BaseT polarity (10).

Ethernet Traffic Indicators (Ethernet LED Bar)

Scan from 2 to 5: Ethernet transmit packet

Scan from 9 to 6: Ethernet receive packet

Other Indicators (on All LED Bars)

Transmit and receive packets - per WAN interface as marked on front
label.

5,6 flashing: Router stacks starting up

3,4 & 7,8 flashing: No OS loaded. Running from ROM.

5,6 on solid, 2 (bars 1 & 3) and 9 (bars 2 & 4) flashing : Erasing OS in
Flash ROM

4,5,6,7 on solid, 2 (bars 1 & 3) and 9 (bars 2 & 4) flashing : Erasing
config in Flash ROM

Scanning from 2 to 9 (bars 1 & 3), and scanning from 9 to 2 (bars 2 &
4): Flash ROM erase due to switch setting five or six is complete. Set
switch to zero and cycle power.

Panic Indicators

Any continuous flashing pattern not noted above may be caused by a
software “panic.” This is a sign that a condition has been detected that
the software does not know how to deal with: either an unusual
network condition, or a hardware failure. Please call Compatible
Systems Technical Support if your router shows a software panic.