Adtran L768 Manuel D’Utilisation

Chapter 3: Terminal Menu Operation and Structure

Express L768/L1.5 User Manual

61202192L1-1

Write security: 3; Read security: 5
When set to Yes, only IP RIP updates are sent when the routing table has  
changed and learned routes are not “aged.” When set to No (def), updates are 
sent periodically.

The IPX menu contains the parameters for exchanging IPX data with the PPP 
peer.

Write security: 3; Read security: 5
Setting to On (def) will permit this connection profile to negotiate PPP IPXCP 
with the PPP peer for exchanging of IPX packets.

Write security: 3; Read security: 5
A non-zero value in this remote network number will allow the Express L768/
L1.5 to add a route to the PPP peer’s network to the routing table.
The Express L768/L1.5 normally will treat the WAN network as an unnum-
bered link.  This is usually referred to as being a “half-router.” However,  a 
PPP peer which wants to assign a network address to the WAN link can do so, 
in which case the Express L768/L1.5 will go into “full-router” mode.

Write security: 3; Read security: 5
When set to Yes, only IPX RIP and SAP updates are sent when the routing or 
service table has  changed and learned routes are not “aged.” When set to No 
(def), updates are sent periodically based on the RIP and SAP timers set in 
Configuration/IPX/RIP Timer

 and Configuration/IPX/SAP Timer.

Write security: 3; Read security: 5
In order for certain protocol implementations, like NetBIOS, to function in the 
NetWare environment, routes must allow a broadcast packet to be propagated 
throughout the IPX networks.  The Type 20 IPX packet is used specifically for