MicroNet Technology MaxNAS Manuel D’Utilisation
MaxNAS Owner’s Manual
11
Step 4. Connect an Ethernet cable from your network to LAN1 (DHCP environment) or LAN2
(static IP) port on the back panel.
Step 5. Press the power button on the front panel. The MaxNAS will boot. The Power indicator
light should glow blue, and the LAN LED corresponding to the connected interface will
glow or blink green. All the HDD Power LEDs on each HDD tray should glow blue.
glow or blink green. All the HDD Power LEDs on each HDD tray should glow blue.
IMPORTANT! If Any LED glows red and the system emits a continuous beeping sound, then the system is
reporting fault. Refer to Appendix A: Troubleshooting for further information.
!
2. Accessing System Administration for the first time
The MaxNAS comes pre-configured with the LAN1 Ethernet port set to DHCP (Dynamic Host
Configuration Protocol) and the LAN2 Ethernet port set to a static IP address, 192.168.2.100.
The current IP addresses are displayed on the LCD panel. The default WINS (Windows Internet
Naming Service) for the MaxNAS is “MaxNAS”. Included with your MaxNAS is a discovery wizard
for Mac and PC, which allows click-and-select
simplicity; simply install the wizard software,
launch it, and the wizard discovers your
MaxNAS for administration.
Configuration Protocol) and the LAN2 Ethernet port set to a static IP address, 192.168.2.100.
The current IP addresses are displayed on the LCD panel. The default WINS (Windows Internet
Naming Service) for the MaxNAS is “MaxNAS”. Included with your MaxNAS is a discovery wizard
for Mac and PC, which allows click-and-select
simplicity; simply install the wizard software,
launch it, and the wizard discovers your
MaxNAS for administration.
IMPORTANT! If you are adding a MaxNAS to a
network with existing MaxNAS products, please make
sure to assign each unit a different name. See Chapter
3, Section 2.3 for more information.
!
2-Connecting the MaxNAS
Chapter 2- Connecting the MaxNAS
1. Connect Your MaxNAS
Place on a flat and stable surface capable of supporting at least 25lbs, and close enough to
the available network jack to reach with an Ethernet cable.
Step 1. Remove the disk canisters from the packing material and carefully insert into the MaxNAS.
Step 2. Secure each canister into position and push the latch until it snaps into place.
Step 3. Connect the provided power cord into the universal power socket on the back panel.
the available network jack to reach with an Ethernet cable.
Step 1. Remove the disk canisters from the packing material and carefully insert into the MaxNAS.
Step 2. Secure each canister into position and push the latch until it snaps into place.
Step 3. Connect the provided power cord into the universal power socket on the back panel.
Plug the other end of the cord into a power socket. Make sure the power switch is in
the on position (“-”)
the on position (“-”)
Step 1- Insert
Canisters
Step 2- Secure
Canister Latches
Step 3- Connect Power
and turn on switch
Step 4- Connect
Network Cable
Step 5- Press Power
Key