Netgear 208-10541-01 Manuel D’Utilisation
RangeMax Wireless-N 150 Router Setup Manual
Help with Troubleshooting
19
v1.0, November 2009
Make sure that the Ethernet cables are securely plugged in:
1.
Verify that the Internet status light on the wireless router will be lit if the Ethernet cable to the
wireless router from the modem is plugged in securely and the modem and wireless router are
both turned on (see
wireless router from the modem is plugged in securely and the modem and wireless router are
both turned on (see
).
2.
Verify that for each powered-on computer connected to the wireless router with a securely
plugged in Ethernet cable, the corresponding wireless router LAN port status light is lit (see
plugged in Ethernet cable, the corresponding wireless router LAN port status light is lit (see
Make sure that the network settings of the computer are correct:
1.
Verify that your LAN connected computers are configured to obtain an IP address
automatically through DHCP. For help with this, see the documentation for your computer or
automatically through DHCP. For help with this, see the documentation for your computer or
2.
Verify whether the MAC address is needed. Some cable modem services require you to use
the MAC address of the computer registered on the account. If so, in the Router MAC Address
section of the Basic Settings menu, select Use this Computer’s MAC Address. To save your
settings, click Apply. Restart the network in the correct sequence.
the MAC address of the computer registered on the account. If so, in the Router MAC Address
section of the Basic Settings menu, select Use this Computer’s MAC Address. To save your
settings, click Apply. Restart the network in the correct sequence.
Check the router status lights to verify correct router operation:
If the Power light does not turn solid green within 2 minutes after you turn the router on, reset the
router according to the instructions in
router according to the instructions in
.
Basic Functions Are Not Working
After you turn on power to the router, check these status lights:
1.
When power is first applied, verify that the Power light is on.
a. Make sure that the power cord is properly connected to your router and that the power
supply adapter is properly connected to a functioning power outlet.
b.
Check that you are using the power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.
2.
Verify that the Test light lights within a few seconds, indicating that the self-test procedure is
running.
running.