Zhone Technologies 4000E Manuel D’Utilisation

20

4000E IP Broadband Loop Carrier Installation Instructions

IPD4-A2-ZZ40-20

— Never install telephone jacks in wet locations unless the jack is 

specifically designed for wet locations.

— Never touch uninsulated telephone wires or terminals unless the 

telephone line has been disconnected at the network interface.

— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an 

electrical storm. There may be a remote risk of electric shock from 

lightning.

— Do not use the telephone to report a gas leak in the vicinity of the 

leak.

13 The equipment is intended for installation in an environment that is free 

of dust and dirt.

14 When installed in the final configuration, the product must comply with 

the applicable Safety Standards and regulatory requirements of the 

country in which it is installed. If necessary, consult with the appropriate 

regulatory agencies and inspection authorities to ensure compliance.

15 CLASS 1 LASER PRODUCT: This product has provisions for the 

customer to install a Class 1 laser transceiver, which provides optical 

coupling to the telecommunication network. Once a Class 1 laser product 

is installed, the equipment is to be considered to be a Class 1 Laser 

Product (Appareil à Laser de Classe 1). The customer is responsible for 

selecting and installing the laser transceiver and for insuring that the Class 

1 AEL (Allowable Emission Limit) per EN/IEC 60825 is not exceeded 

after the laser transponders have been installed. Do not install laser 

products whose class rating is greater than 1. Refer to all important safety 

instructions that accompanied the transceiver prior to installation. Only 

laser Class 1 devices certified for use in the country of installation by the 

cognizant agency are to be utilized in this product. Also, laser warnings 

are to be provided in accordance with IEC 60825-1 and its Amendments 1 

and 2, as well as 21 CFR 1010 and 1040.10(g).

This equipment has been tested and found to comply with the limits for a 
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are 
designed to provide reasonable protection against harmful interference when 
the equipment is operated in a commercial environment. This equipment 
generates, uses, and can radiate radio frequency energy and, if not installed 
and used in accordance with the instruction manual, may cause harmful 
interference to radio communications. Operation of this equipment in a 
residential area is likely to cause harmful interference in which case the user 
will be required to correct the interference at his own expense.

The authority to operate this equipment is conditioned by the requirements 
that no modifications will be made to the equipment unless the changes or 
modifications are expressly approved by Zhone Technologies, Inc.