3com 10014299 Mode D'Emploi

C

HAPTER

 45: C

ONFIGURING

 

A

 S

TANDBY

 C

ENTER

priority; after the logic channel changes to up, it's required to switch from the 
standby interface with the second highest priority to this logic channel.

Perform the following commands in the view of the logic channel.

Table 701   Set the State-judging Conditions When the Main Interface is a Logic Channel

By default, time is set to 0 and seconds is set to 1 second. 

Conduct the following configuration under the interface view or logic channel 
view. 

Table 702   Configure Interface or Logic Channel Load Sharing

By default, the standby load sharing function of interface is not enabled.

Please perform the following configuration in all views.

Table 703   Display and Debug Standby Center

This section describes several different configurations for standby centers with a 
suggested procedure for each configuration

Take interface Serial 2 as the standby interface for interface Serial 1.

1 Enter the view of Serial 1.

[Router]interface serial 1

2 Set Serial 2 as its standby interface.

[Router-Serial1]standby interface serial 2

3 Set the time for switchover between main and standby interfaces as 10 seconds.

[Router-Serial1]standby timer enable-delay 10

[Router-Serial1]standby timer disable-delay 10

Set the condition for judging the logic channel as 
down: the logical channel is regarded as down after 
the specified number of unsuccessful calls.

seconds is set to make regular inspections so as to 
check whether the original logic channel has 
recovered its “up” state.

Configure the standby load sharing of 
interface or logic channel

standby threshold enable-threshold 

Disable the standby load sharing 
configuration of interface and logic 
channel 

enable-threshold disable-threshold

Turn on the standby center debugging