Sony NSP-100 Manuel D’Utilisation

NSP 100

Op
er

at

io

n

Starting Up and Initial Settings

10

When you connect a monitor to the unit, and power on 
for the first time, the starting screen appears and it is 
then followed by the initial setting screen.

r

When the initial setting screen appears, carry out the 
following procedure using the remote controller.

With the b and B buttons, select the language you 
want to use in the menus, and press the ENTER 
button.

This confirms the language selection, and the 
“Network Setup” screen appears.

Press the ENTER button.

It becomes possible to select whether or not to use 
a network.

With the b and B buttons, select whether or not to 
use a network, then press the ENTER button.

• If you select “No,” the screen changes as follows.

In this case, skip to step 

.

To return to the previous screen instead of 
advancing to step 

, press the b button.

• If you select “Yes,” next press the ENTER button.

The “Network Setup” screen reappears.

Using the v and V buttons, select the item you want 
to set, then press the ENTER button.

The setting can now be changed.

Using the b and B buttons, select the group to set 
within the selected item.

Enter the setting with the numeric buttons (0 to 9).
Alternatively, adjust the setting with the v and V 
buttons.

Press the ENTER button.

This confirms the setting of the selected item.

Repeat steps 

 to 

 until all of the required items 

have been set.