Emerson PME1 Manuel D’Utilisation
Regulatory Agency Warnings & Notices
(continued)
10002367-02
PmT1 and PmE1 User’s Manual
iii
Information shall be provided as to the power source requirements. See the PmT1 and PmE1 power requirements in the hardware manual.
If the device is enclosed in an assembly, and not readily accessible, a label shall be placed on
the exterior of the cabinet listing the registration number of each PmT1 and PmE1 con-
tained therein.
the exterior of the cabinet listing the registration number of each PmT1 and PmE1 con-
tained therein.
The final assembler shall provide, in the consumer instructions, all applicable Network Con-
nection Information.
nection Information.
INDUSTRY CANADA RULES AND REGULATIONS — CS03
NOTICE: The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective, operational,
and safety requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not guarantee the equipment will oper-
ate to the user’s satisfaction.
that the equipment meets certain telecommunications network protective, operational,
and safety requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not guarantee the equipment will oper-
ate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected
to the facilities of the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. The customer should be aware that
compliance with the above conditions may not prevent degradation of service in some situ-
ations.
to the facilities of the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. The customer should be aware that
compliance with the above conditions may not prevent degradation of service in some situ-
ations.
Repairs to certified equipment should be coordinated by a representative designated by
the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to dis-
connect the equipment.
the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to dis-
connect the equipment.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines, and internal metallic water pipe system, if present, are con-
nected together. This precaution may be particularly important in rural areas.
power utility, telephone lines, and internal metallic water pipe system, if present, are con-
nected together. This precaution may be particularly important in rural areas.
Caution:
Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician as appropriate.
appropriate electric inspection authority, or electrician as appropriate.
The standard connecting arrangement code (telephone jack type) for this equipment is
CA48C.
CA48C.
!